In electroerosive machining, a programmed contour is cut into a workpiece with
the help of a metal wire (electrode). Wire EDM is used for the manufacture
of dies, moulds and specific metal parts.
Wire EDM is often a cost effective alternative for parts with
complex contours.
As a special service we offer conic machining (conic angle/height °/mm ±30/400)
and workpieces of 2,000 mm of length.
Machinery wire EDM:
Mitsubishi FX 20 K
Charmilles Robofil 400:
Traverses (X/Y/Z)
mm 500x350x300
Traverses (X/Y/Z) mm 450x320x220
U/V ±50/±50 mm
Max. size of the workpiece
mm BxTxH 1.050x800x295
Max. size of the workpiece
mm 200 (Option: mm 260)
Max. weight of the workpiece kg 800
Max. height of the workpiece mm 200
Size of the table mm 780x630
Angular adjustability from 0 to 30°
Length of the workpiece up to 2.000 mm in water bath!
Charmilles Robofil 290P
Charmilles Robofil 440cc
Traverses (X/Y/Z) mm
500x350x300
U/V 400/250 mm
Traverses (X/Y/Z)
mm 550x350x400
U/V 550/350 mm
Conic angle / height ± 30/200
Conic angle / height °/mm ±30/400
Max. size of the workpiece
mm BxTxH 850x500x200
Max. size of the workpiece
mm BxTxH 1.200x700x400
Max. weight of the workpiec kg 500
Max. weight of the workpiec kg 1.500
Charmilles Robofil 310
Traverses (X/Y/Z)
mm 400x250x400
U/V 400/250 mm
Max. size of the workpiece
mm BxTxH 850x500
Max. weight of the workpiec 500
Max. height of the workpiece mm 400
Drill for initial hole Cobracut B
Movement: X275 Y150 Z200 (300)
Diameter of electrode: 0.3-3.0
